Toyota Land Cruiser

 Service Manual

SFI » Curtain shield airbag assembly
Installation

NOTICE: Never use airbag parts from another vehicle. When replacing parts, replace them with new parts.

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

(a) In the order shown in the illustration, install the curtain shield airbag with the 8 bolts.

Torque: 9.8 N·m (100 kgf·cm, 86 in.·lbf)

CAUTION: Pay due attention not to twist the deployment section of the curtain shield airbag assembly.

NOTICE:

• Make sure that the curtain shield airbag assembly is installed to the specified torque.
• If the curtain shield airbag assembly has been dropped, or there are cracks, dents or other defects in the case or connector, replace the curtain shield airbag assembly with a new one.
• When installing the curtain shield airbag assembly, take care it is not pinched between other parts.

(b) Connect the connector of the curtain shield airbag assembly.

2. INSTALL ROOF HEADLINING (BO-101 )

3. INSPECT SRS WARNING LIGHT (DI-692 )

Disposal

Inspection

Installation

Removal

Replacement