Toyota Land Cruiser

 Service Manual

Suspension & Axle » Front upper suspension ARM
Removal

1. REMOVE FRONT WHEEL

Torque: 131 N·m (1,340 kgf·cm, 97 ft·lbf)

2. REMOVE FRONT FENDER APRON

3. DISCONNECT ABS SPEED SENSOR WIRE HARNESS

Remove the 2 bolts and disconnect the ABS speed sensor wire harness.

Torque: 13 N·m (130 kgf·cm, 10 ft·lbf)

4. DISCONNECT STEERING KNUCKLE FROM UPPER SUSPENSION ARM

(a) Support the lower suspension arm with a jack.

(b) Remove the cotter pin and nut.

Torque: 110 N·m (1,125 kgf·cm, 81 ft·lbf)

HINT: At the time of installation, if the holes for the cotter pin are not aligned, tighten the nut further up to 60.

(c) Using SST, disconnect the steering knuckle from the upper suspension arm.

SST 09628-6201 1

5. REMOVE UPPER SUSPENSION ARM

(a) Place matchmarks on the front and rear No. 2 adjust cams and body.

(b) Remove the 2 nuts, No. 1 and No. 2 camber adjust cams and upper suspension arm.

Torque: 98 N·m (1,000 kgf·cm, 72 ft·lbf)

HINT: At the time of installation, after stabilizing the suspension, torque the nuts.

Inspection

Removal

Replacement